Subaru Forester

1. The car also establish to Poddomkratta it on props.
2. Remove the corresponding forward wheel
3. By means of a chisel to a raschekanta a stupichny nut.
4. Remove a support of the brake mechanism from a rotary fist and, without disconnecting from it hydraulic shlag, tie up a wire to suspension bracket elements.
5. Disconnect the wheel ABS sensor.
6. Remove a brake disk.
7. Release a spherical support from assembly of a rotary fist.
8. Take the forelock and release a nut of fastening of a tip of steering draft. By means of a stripper release a tip from a fist.
9. Mark the provision of a head of a razvalny bolt, then turn out bolts of fastening of a rotary fist to a suspension bracket rack.
10. Release a power shaft from a fist.

1. Install assembly of a rotary fist on the assembly stupichny stand. And by means of special devices to a vypressuyta a nave. Take an internal epiploon and a lock ring.
2. Prop up a fist and release from it the internal bearing.
3. Remove a rotor ring of the wheel ABS sensor from a nave.
4. By means of a stripper release the bearing and an epiploon from a nave.

1. Establish a fist in a press and by means of the special tool (927080000) and the stupichny stand (927060000) put in it bearings and epiploons. Track that bearings were properly greased, before installation of an internal epiploon do not forget to put a lock ring.
2. At the corresponding complete set establish a rotor of the wheel ABS sensor on a nave.
3. Press a nave in assembly of a rotary fist.