Subaru Forester

1997-2005 of release

Repair and operation of the car


Subaru Forester
+ Subaru Forester cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Gear shifting box
+ Coupling, transmission line
- Brake system
   Specifications
   System of anti-blocking of brakes (ABS) - the general information and diagnostic checks
   Removal and installation of the main ABS components
   Check and adjustment of height of situation and free wheeling of a pedal of a foot brake
   Adjustment of a rod of a pusher of GTTs / vacuum amplifier of brakes
   Check and adjustment of the drive of the parking brake
   Check of serviceability of functioning of the vacuum amplifier of brakes
   Replacement of brake shoes of disk brake mechanisms
   Removal and installation of supports of disk brake mechanisms
   Check of a state, removal and installation of a brake disk
   Replacement of boots and service of drum brake mechanisms of back wheels
   Removal and installation of components of assembly of the parking brake (model with disk brake mechanisms of back wheels)
   Removal and installation of the main brake cylinder
   Check of a state and replacement of brake lines and hoses
   Removal and installation of assembly of the vacuum amplifier of brakes
   Pumping of the brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Removal and installation of components of assembly of the parking brake (model with disk brake mechanisms of back wheels)

Removal

Design of disk brake mechanisms of back wheels

1  —  the Support
2  —  the pumping Gate
3  —  the Directing finger (green)
4  —  the Protective cover
5  —  the Sealing cuff
6  —  the Piston
7  —  the Boot
8  —  the Lock ring
9  —  the Blocking finger (yellow)
10  —  the Anchor bracket
11  —  Spring clamps of blocks
12  —  the Internal block
13  —  the External block
14  —  Adjusting laying
15  —  the Anchor finger
16  —  the Cap
17  —  the Brake board

18  —  the Holder
19  —  the Spring washer
20  —  the Executive lever of the drive of the parking brake
21  —  the Back boot of the parking brake
22  —  the Forward boot of the parking brake
23  —  Razzhimnaya a level
24  —  Razzhimnaya a spring
25  —  the Directing plate
26  —  the Returnable spring of a back boot
27  —  the Returnable spring of a forward boot
28  —  the Adjusting spring
29  —  the Regulator
30  —  the Plate of the directing spring
31  —  the Directing spring
32  —  the Brake disk


 PERFORMANCE ORDER

1. Remove assembly of the disk brake mechanism from an anchor bracket and take her aside.
2. Having passed the screw-driver throughout a special opening in a brake board (previously take a cap) and rotating it a regulator cogwheel, weaken a clip of brake boots to drum walls. Remove a brake disk from a nave.
3. Disconnect returnable springs of boots. Remove the directing spring and an anchor finger of a forward boot.
4. Remove a razzhimny level and its spring.
5. Remove assembly of the regulator.
6. Take off a boot.
7. Remove the directing spring and an anchor finger of a back boot.
8. Disconnect a driving cable from the executive lever of the parking brake.
9. Remove the lever and its adjusting washers from a boot.


Installation

 PERFORMANCE ORDER

1. Installation is made upside-down.
2. In conclusion adjust the drive of the parking brake (see the Section Check and adjustment of the drive of the parking brake).