Subaru Forester
+ Subaru Forester cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Gear shifting box
+ Coupling, transmission line
- Brake system
Specifications
System of anti-blocking of brakes (ABS) - the general information and diagnostic checks
Removal and installation of the main ABS components
Check and adjustment of height of situation and free wheeling of a pedal of a foot brake
Adjustment of a rod of a pusher of GTTs / vacuum amplifier of brakes
Check and adjustment of the drive of the parking brake
Check of serviceability of functioning of the vacuum amplifier of brakes
Replacement of brake shoes of disk brake mechanisms
Removal and installation of supports of disk brake mechanisms
Check of a state, removal and installation of a brake disk
Replacement of boots and service of drum brake mechanisms of back wheels
Removal and installation of components of assembly of the parking brake (model with disk brake mechanisms of back wheels)
Removal and installation of the main brake cylinder
Check of a state and replacement of brake lines and hoses
Removal and installation of assembly of the vacuum amplifier of brakes
Pumping of the brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of assembly of the vacuum amplifier of brakes
|
|
The block of the vacuum amplifier of brakes is not subject to recovery repair and in case of refusal has to be replaced assembled! |
Removal
Check of a free wheeling of a pedal of a foot brake
|
|
|
1. Disconnect the vacuum hose brought to the amplifier from the inlet pipeline of the engine. Try not to damage a hose, removing it from the union on assembly of the amplifier.
2. In interior of the car find knot of connection of a rod of a pusher of the vacuum amplifier to a pedal of a foot brake, - (in case of need use a pocket small lamp). At first disconnect a returnable spring, then take the forelock, release a cylindrical pin and disconnect a cutting finger of a pusher from the pedal lever.
3. Give fixing nuts and carefully remove from assembly of the vacuum amplifier the main brake cylinder (see the Section Removal and installation of the main brake cylinder) - try not to allow bending and twisting of hydraulic lines.
4. From salon at the left under the dashboard give four nuts of fastening of assembly of the vacuum amplifier to a partition of a motive compartment, - in case of need use a pocket small lamp.
5. Pass into a motive compartment and remove assembly of the vacuum amplifier from a back partition. Pull assembly strictly on an axis of its installation before full release of a rod of a pusher. Take assembly from a motive compartment. |
|
Installation and adjustment
Check of size of a vystupaniye of a rod of a pusher of GTTs of the vacuum amplifier of brakes
|
|
|
1. Installation is made upside-down. Tighten all fixture with the required effort. Do not forget to replace the forelock of a pin of fastening of a rod of a pusher to a pedal. Track reliability of fixing of a returnable spring.
2. Check the size of a vystupaniye of the "L" rod of a pusher of GTTs, - demanded value makes 10.00 mm.
3. Working as it should be, the return to a dismantle order, establish assembly of the vacuum amplifier of brakes on the regular place, - act extremely carefully, try not to allow applyings of side loadings to a pusher rod. In case of need replace a protective cover of a rod.
4. In conclusion pump over a hydraulic path of the brake system (see the Section Pumping of the Brake System). |
|
|
|