Subaru Forester
+ Subaru Forester cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Gear shifting box
+ Coupling, transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
Specifications
Search of causes of failures of electric equipment
Safety locks - the general information
Chain breakers - the general information
The relay - the general information and check of serviceability of functioning
System of additional safety (SRS) - the device and the principle of functioning
Removal and installation of the SRS components
Diagnostics of malfunctions of SRS
Control system of speed (темпостат) - the device and the principle of functioning
Adjustments of components of a tempostat
Check of serviceability of functioning of components and failure diagnostics of a tempostat
Removal and installation of components of a control system of speed
Heating of back glass and rear-view mirrors - the general information, check of serviceability of functioning, recovery repair
Combination of devices - the general information, check of serviceability of functioning of components
Removal and installation of a combination of devices
The electric drive of rear-view mirrors - the general information, check of serviceability of functioning of components
Removal and installation of components of the electric drive of rear-view mirrors
The electric drive of door window regulators - the general information, check of serviceability of functioning of components
Removal and installation of regulators of window regulators
The uniform lock - the device and the principle of functioning, diagnostics of malfunctions, check of a condition of components
Removal and installation of activators of door locks
Switches of a steering column - the general information, check of serviceability of functioning
Removal and installation of switches of a steering column
Cleaners and washers of glasses - the general information, adjustment and check of a condition of components
Removal and installation of components of cleaners/washers of glasses
Replacement of lamps of lighting fixtures
The radio receiver antenna - the general information
The audio system - the general information
+ Schemes of electric connections - the general information
|
Adjustments of components of a tempostat
Cable of the drive of a butterfly valve
Measure gap size between an emphasis and the cam lever of the drive of a butterfly valve.
Adjustment of a cable of the drive of a butterfly valve
If the result of measurement differs from nominal rate (1.0 mm), weaken adjusting nuts and shift a cable cover in the relevant party, trying to obtain reduction of a gap in norm. Cover shift towards the lever leads to increase in a gap and vice versa.
Sensors switches of stoplights and disconnection of a chain of a starter
Sensors switches are installed on arms of the corresponding pedals of the car. Weaken a sensor switch lock-nut. At the released pedal screw the sensor switch so that its plunger nestled on an emphasis of a pedal and it was drowned on 1.5 ÷ 3.0 mm. Tighten a lock-nut and check conductivity of the sensor switch (see the Section Check of Serviceability of Functioning of Components and Failure Diagnostics of a Tempostat). |
|