Subaru Forester

1997-2005 of release

Repair and operation of the car


Subaru Forester
+ Subaru Forester cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling systems, heating
- Power supply system and release
   Specifications
   System of production of the fulfilled gases - the general information
   Measurement of pressure of fuel
   Dumping of pressure in a power supply system
   Principle of action and check of serviceability of functioning of the fuel pump
   Service of the fuel filter
   Check of a state and replacement of fuel lines and their nipple connections
   Service of the cross over valve
   Removal and installation of the case of a throttle
   Fuel injection injectors - the general information and service
   The fuel pressure regulator - general information
   Cleaning and repair of the fuel tank - general information
   Removal and installation of the sensor of measurement of mass of air (MAF)
   Check of serviceability of functioning of system of electronic injection
   System of a turbo-supercharging - the general information
   Service of system of a turbo-supercharging
   System of release - the general information
+ Engine electric equipment
+ Control systems of the engine
+ Gear shifting box
+ Coupling, transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Removal and installation of the case of a throttle

Remember that gasoline is extremely flammable liquid!

During the work with components of a power supply system observe all taken measures of fire safety.

Do not smoke! Do not approach the venue of works with naked flame or the carrying unprotected by the lamp shade!

You do not make service of system in the rooms equipped with the heating devices using natural gas and equipped with a control torch (such as vodogre and dryers for clothes).

Do not forget that gasoline is among cancerogenic substances, i.e., - the substances promoting development of cancer!

Try not to allow hits of fuel on open parts of the body, use rubber protective gloves, at casual unforeseen contact with fuel carefully wash out hands warm water with soap.

Immediately collect the spilled fuel and do not put the rags impregnated with fuel and lubricants near sources of naked flame.

Remember that the power supply system of the models equipped with injection of fuel constantly is under pressure.
Before starting a detachment of fuel lines, dump residual pressure in system.

At service of components of a power supply system put on goggles. Constantly hold near at hand the class B fire extinguisher!

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!


 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Release a collar of fastening of a sleeve of an air inlet to the delivery camera of an air path and assembly of the MAF sensor.
3. Weaken a collar of fastening of the delivery camera of an air path to the throttle case.
4. Disconnect perepuskny and air hoses and remove the delivery camera assembled with an air inlet sleeve.
5. Disconnect cables of gas (A) and the drive of a tempostat (In).
6. Disconnect an electrical wiring from the sensor of provision of a butterfly valve (TPS).
7. Disconnect hoses of a cooling path from the throttle case.
8. Turn out fixing bolts and remove the throttle case from the inlet pipeline.
9. Installation is made upside-down, - do not forget to replace sealing laying, track that fixture was tightened with the required effort (22 Nanometers: for the throttle case; 5 Nanometers: for the delivery camera).