Subaru Forester
+ Subaru Forester cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
- Engine electric equipment
Specifications
Start of the engine from the auxiliary power supply
Removal and installation of the rechargeable battery
Check of a state and replacement of wires of the battery
System of ignition - the general information and precautionary measures
Check of serviceability of functioning of system of ignition
Assembly of coils of ignition - the general information, check of a state and replacement
Check and adjustment of installation of a corner of an advancing of ignition
Replacement of the module of ignition
Check of serviceability of functioning of CKP, CMP sensors and detonation
Service of spark plugs
Check of a condition of high-voltage wires
System of a charge - the general information and precautionary measures
Generator, general information, check and service
Removal and installation of the generator
System of start - the general information and precautionary measures
Check of serviceability of functioning of a starter and chain of start
Nippondenso starters - check and service
Mitsubishi starters - check and service
+ Control systems of the engine
+ Gear shifting box
+ Coupling, transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Replacement of the module of ignition
|
|
|
|
1. In the considered models used on systems of direct ignition the module of ignition of single sparking providing simultaneous breakdown interelectrode gaps of spark plugs at once of two cylinders is used (in provisions of the ends of a step of compression and release of pistons). On a signal the ECM module of ignition develops the command for operation of the coil of ignition providing simultaneous sparking at once in two cylinders of the engine (1 and 2, or 3 and 4 respectively).
2. Remove the delivery camera of an air path (see the Section Fuel Pressure Regulator - general information of the Head of the Power supply system and release. |
| 3. Disconnect an electrical wiring from the ignition module. |
|
| 4. Turn out fixing screws and remove the ignition module from a body element. |
|
|
Installation is made upside-down. |
|