Subaru Forester
+ Subaru Forester cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
- Gear shifting box
- 5-staged manual box of gear shifting (MBGS)
General information
Removal and installation of a box of gear shifting
Preparation for performance of repair work on restoration of RKPP
Dismantling and assembly of the transfer case, service of components
Capital repairs of RKPP of all-wheel drive models
Service of the drive of gear shifting
Service of the lever of switching of the transfer case
+ 4-staged automatic transmission (AT)
+ Coupling, transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of a box of gear shifting
Removal
Scheme of connection to RKPP of drafts of the mechanism of gear shifting
Removal of a collar of fastening of a bar of the stabilizer of cross resistance to the cross lever
|
|
If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action! |
|
|
|
|
1. Open a cover of a cowl and record it in open situation.
2. Disconnect a negative wire from the battery.
3. On the models equipped with a turbo-supercharging remove assembly of an intermediate cooler (see the Head of the Power supply system and release).
4. Remove the corresponding elements of system of an admission of air. |
5. Disconnect the forward oxygen sensor, the tire of grounding of transmission and the other electrical wiring impeding performance of work. Disconnect an electrical wiring from the sensor switch of neutral provision of RKPP, the sensor switch of fires of a backing and VSS. At the corresponding complete set of the car disconnect cables of the drive of coupling and system of keeping of the car on a bias.
1 — Draft
2 — Connecting draft
3 — Pruzhina |
|
6. Remove the executive cylinder of coupling.
7. Remove the torsion bar established between the power unit and a body of the car.
8. Remove a starter.
9. On models with a turbo-supercharging separate a fork of switching off of coupling from the release bearing.
10. Hang out the engine by means of the special beam established on a body of the car (927670000). The car also establish to Poddomkratta it on props. Remove forward and back sections of system of production of the fulfilled gases. Remove the thermofilter of system of release.
11. At the corresponding complete set remove a beam of a forward suspension bracket. Remove the driveshaft, previously having marked its adjusting situation. Remove the central bearing of the driveshaft.
12. Zakuporte an opening in back walls of a casing of lengthening of transmission. Disconnect a rod of the choice of transfers from a transmission lath.
13. Remove a transmission suspension bracket support arm. Disconnect from the transmission of draft of the mechanism of switching.
14. By means of a suitable drift beat out cylindrical pins of fastening of both power shafts. Disconnect a bar of the stabilizer of cross stability from the cross lever. Release from clamps on the lever a cable of the drive of the parking brake. Turn out a bolt of fastening of the cross lever to a beam of a forward suspension bracket, then release power shafts from transmission. |
| 15. Release bolts/nut of fastening of the transmission to the engine, then prop up transmission a cart jack. Give nuts of pillows of a back support and remove a back beam of a suspension bracket. |
|
16. Separate transmission from the engine and take it from under the car.
17. Remove the lever of switching off and the release bearing of coupling from transmission assembly, also remove the holder of the bearing. |
|
Installation
Installation is made upside-down, - see also Head Stsepleniye, the transmission line. Do not forget to replace cylindrical pins of fastening of power shafts. Tighten all fixture with the required effort. |
|