Subaru Forester

1997-2005 of release

Repair and operation of the car



Subaru Forester
+ Subaru Forester cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Gear shifting box
+ Coupling, transmission line
- Brake system
   Specifications
   System of anti-blocking of brakes (ABS) - the general information and diagnostic checks
   Removal and installation of the main ABS components
   Check and adjustment of height of situation and free wheeling of a pedal of a foot brake
   Adjustment of a rod of a pusher of GTTs / vacuum amplifier of brakes
   Check and adjustment of the drive of the parking brake
   Check of serviceability of functioning of the vacuum amplifier of brakes
   Replacement of brake shoes of disk brake mechanisms
   Removal and installation of supports of disk brake mechanisms
   Check of a state, removal and installation of a brake disk
   Replacement of boots and service of drum brake mechanisms of back wheels
   Removal and installation of components of assembly of the parking brake (model with disk brake mechanisms of back wheels)
   Removal and installation of the main brake cylinder
   Check of a state and replacement of brake lines and hoses
   Removal and installation of assembly of the vacuum amplifier of brakes
   Pumping of the brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Check of serviceability of functioning of the vacuum amplifier of brakes

 PERFORMANCE ORDER

1. Start the engine, let's it work within two-three minutes, then muffle.
2. Several times squeeze out a pedal of a foot brake with normal effort, - at each muscleman height of provision of the squeezed-out pedal has to increase.
3. Holding a pedal of squeezed out, start the engine, - the pedal has to fail considerably.
4. Without releasing a pedal, kill the engine and hold a pedal squeezed out within not less than 30 seconds, - for the stipulated time height of provision of a pedal should not change. Insignificant raising of a pedal will demonstrate existence of leaks in the amplifier, - check serviceability of functioning of the control valve. If the valve as it should be, replace assembly of the servo-driver of the amplifier.