Subaru Forester

1. The car also establish to Poddomkratta it on props. Remove back wheels.
2. Give a stupichny nut.
3. Release an adjusting nut of the lever of the drive of the parking brake.
4. Remove from stupichny assembly a support and a disk of the brake mechanism (model with disk brake mechanisms of back wheels).
5. Remove the brake drum and disconnect the brake line from the wheel cylinder (model with drum brake mechanisms of back wheels).
6. Disconnect a cable of the drive of the parking brake.
7. Disconnect a bar of the stabilizer of cross stability from the back cross lever of a suspension bracket.
8. Turn out bolts of fastening of cross levers to stupichny assembly.
9. Turn out a fastening bolt to stupichny assembly of the longitudinal lever of a suspension bracket.
10. At the corresponding complete set of the car remove the wheel ABS sensor.
11. Remove a spring lock ring of fastening of a half shaft to differential.
12. Remove a half shaft.
13. Separate stupichny assembly from a suspension bracket rack.
14. Remove a brake board.
15. Remove epiploons and a lock ring.
16. For removal of the bearing use the stand (927430000) and a stripper (927440000).
17. Remove a casing of stupichny assembly, transfer it to the assembly stand (927080000) and by means of a stripper (927420000) dismantle a nave.

1. Remove garbage from a casing of stupichny assembly.
2. By means of the stand (927430000) and a mandrel (927460000) establish an internal epiploon of stupichny assembly, - the epiploon refuels against the stop in a bottom of a landing nest.
3. Establish an additional epiploon, - sponges of epiploons should be greased with lubricant of type No. 6459.
4. Establish a brake board.
5. For landing in a nave of the bearing use the stand (927080000) and a mandrel (927450000).
6. Further installation is made as it should be, the return to an order of dismantle of components.