Subaru Forester
+ Subaru Forester cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Gear shifting box
+ Coupling, transmission line
+ Brake system
- Suspension bracket and steering
Specifications
Check of a condition of spherical support of a forward suspension bracket
Check of a condition of forward wheel bearings
Removal and installation of a cross beam of a forward suspension bracket
Removal and installation of a rotary fist with the wheel bearing, service of stupichny assembly
Removal and installation of the lower lever of a forward suspension bracket with a spherical support
Service of racks of a forward suspension bracket
Removal and installation of the forward stabilizer of cross stability
Check of a condition of back wheel bearings
Removal and installation of a cross beam (stretcher) of a back suspension bracket
Removal, service and installation of racks of a back suspension bracket
Removal and installation of back wheel bearings
Pumping of a hydraulic path of the steering drive
Adjustment of a side play of gearing of rack transfer
Verification of the pressure head characteristic of the steering pump
Check of effort of rotation of the steering mechanism
Removal and installation of the steering pump
Removal and installation of the steering mechanism
Capital repairs of the steering pump
Capital repairs of the steering mechanism
Steering column, - the general information, precautionary measures
Removal and installation of the module of a safety cushion
Removal and installation of a steering wheel
Removal and installation of assembly of the combined understeering switches
Removal and installation of the lock of ignition/blocking of a steering column
Removal and installation of a steering column
Capital repairs of a steering column
Wheels and tires - the general information
Adjustment of geometry of a suspension bracket
+ Body
+ Onboard electric equipment
|
Check of effort of rotation of the steering mechanism
|
|
|
|
1. Tire out the car on the flat horizontal platform with a concrete covering, leave the engine working at single turns.
2. Check of effort of a provorachivaniye of a steering wheel is made by means of a spring dynamometer (steelyard). The result of measurement should not exceed values of 3 kgfs in both directions of rotation.
3. Repeat measurement at the killed engine, - the effort of a provorachivaniye has to increase approximately by 10 times (no more than 30 kgfs).
4. In case of negative results of checks it is necessary to make adjustment of a side play of gearing of rack transfer (see the Section Adjustment of a Side Play of Gearing of Rack Transfer).
5. If adjustment of rack transfer does not lead to correction of a situation (by results of repeated check), disconnect the cardan hinge from a steering column, - now the effort of a provorachivaniye has to make no more than 0.23 kgfs, otherwise it is necessary to check a state and reliability of fastening of tips of steering drafts and spherical support of a suspension bracket. Make sure also that the cardan hinge is not jammed. |
| 6. Remove assembly of the steering mechanism (see the Section Removal and installation of the steering mechanism) and measure effort of a provorachivaniye of its entrance shaft at the disconnected cardan hinge. The result of measurement should not make more than 1.3 kgfs. |
|
| 7. Remove internal tips of steering drafts and by means of a spring dynamometer measure resistance of sliding of a lath. The result of measurement should not exceed value in 31 kgfs, and the difference between measurements at a lath pulling diversely also should not go beyond a limit in 20%. |
|
|
|