| 1. The car also establish to Poddomkratta it on props.
2. Remove the stabilizer of cross stability (see the Section Removal and installation of the forward stabilizer of cross stability) and a poddomkratny plate.
3. Remove a basic arm of a cable of the drive of the parking brake from the lower lever of a suspension bracket.
4. Disconnect steering drafts from rotary fists.
5. Remove a reception pipe of system of production of the fulfilled gases (see the Head of the Power supply system and release).
6. Disconnect the lower levers of a suspension bracket from a cross beam.
7. Give fastening nuts to a cross beam of a support of a suspension bracket of the power unit.
8. Give nuts of fastening of the twisting rod and a shaft of the drive of the steering mechanism.
9. Hang out the power unit, having raised it over a suspension bracket beam approximately on 10 mm.
10. Prop up a beam a jack.
11. Give fixing beams and remove a beam assembled with rack transfer.
12. Installation is made upside-down. Final tightening of nuts of fastening of a beam, and also fastening bolts to it the lower levers of a suspension bracket it is necessary to make the earth after lowering of the car. Track that all fixture was tightened with the required effort. |